The new Leica TDRA6000 introduces new and improved technology. With an all new direct drive technology, reflectorless measurements and a typical 3D point accuracy of 0.25 mm at 35 meters, this new generation of Laser Station incorporates Leica Geosystems’ long experience developing industrial laser stations.
The new Leica TDRA6000 is the most accurate total station ever designed for industrial use. This new Leica Geosystems laser station has the ability to automatically target both CCR and tape targets and can even measure without targets maintaining a typical reflectorless accuracy of 1 mm. Optimized for use within 300 meters and combined with the Leica Geosystems PowerSearch module, the new Leica TDRA6000’s tracking performance is simply unbeatable.
An all new Leica Geosystems proprietary direct drive technology has been designed from the ground up for this new sensor. Based on Piezo technology, these new direct drives enable high speed motorization and acceleration, at up to 4x the previous generation, but still allow sub micron level fine positioning. This technology has very low power consumption, requires almost no maintenance and is near silent.
Combined with the right software package like DCP05 or Microlog, the Leica TDRA6000 is a top level solution for industrial metrology.
Ønsker du mere information?
Ønsker du mere information om dette produkt?
Vælg hvad du søger efter, vælg land, klik derefter på [Fortsæt] for at finde din nærmeste Leica Geosystems kontakt:
